PLANET SGSD-1022 - Manual (Page 552)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Default Setting
Long method
Command Mode
Global Configuration
Command Usage
The path cost method is used to determine the best path between devices. Therefore, lower values should be assigned to
ports attached to faster media, and higher values assigned to ports with slower media. Note that path cost (page 4-211)
takes precedence over port priority (page 4-213).
Example
Console(config)#spanning-tree pathcost method long
Console(config)#
spanning-tree transmission-limit
This command configures the minimum interval between the transmission of consecutive RSTP/MSTP BPDUs. Use the no form
to restore the default.
Syntax
spanning-tree transmission-limit count no spanning-tree transmission-limit
count - The transmission limit in seconds. (Range: 1-10)
Default Setting
3
Command Mode
Global Configuration
Command Usage
This command limits the maximum transmission rate for BPDUs.
Example
Console(config)#spanning-tree transmission-limit 4
Console(config)#
spanning-tree mst-configuration
This command changes to Multiple Spanning Tree (MST) configuration mode.
Default Setting
No VLANs are mapped to any MST instance.
The region name is set the switch’s MAC address.
552