PLANET SGSD-1022 - Manual (Page 658)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Command Usage
Each profile has only one access mode; either permit or deny.
When the access mode is set to permit, IGMP join reports are processed when a multicast group falls within the controlled
range. When the access mode is set to deny, IGMP join reports are only processed when a multicast group is not in the
controlled range.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#permit
Console(config-igmp-profile) #
range
This command specifies multicast group addresses for a profile. Use the no form to delete addresses from a profile.
Syntax
[no] range low-ip-address [high-ip-address]
low-ip-address - A valid IP address of a multicast group or start of a group range.
high-ip-address - A valid IP address for the end of a multicast group range.
Default Setting
None
Command Mode
IGMP Profile Configuration
Command Usage
Enter this command multiple times to specify more than one multicast address or address range for a profile.
Example
Console(config-igmp-profile)#range 239.1.1.1
Console(config-igmp-profile)#range 239.2.3.1 239.2.3.100
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#
ip igmp filter (Interface Configuration)
This command assigns an IGMP filtering profile to an interface on the switch. Use the no form to remove a profile from an
658