PLANET SGSD-1022 - Manual (Page 501)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Eth 1/1 DISABLED
Eth 1/2 DISABLED
Eth 1/3 DISABLED
Eth 1/4 DISABLED
Eth 1/5 SIP
Eth 1/6 DISABLED
show ip source-guard binding
This command shows the source guard binding table.
Syntax
show ip source-guard binding [dhcp-snooping | static]
dhcp-snooping - Shows dynamic entries configured with DHCP Snooping commands (see page 4-146)
static - Shows static entries configured with the ip source-guard binding command (see page 4-155).
Command Mode
Privileged Exec
Access Control List Commands
Example
Console# show ip source-guard binding
MacAddress IpAddress Lease(sec) Type VLAN Interface
---------------------- ------------------ ---------- -------- ------ -----------
11-22-33-44-55-66 192.168.0.99 0 Static 1 Eth 1/5
Console#
5.14 Access Control List Commands
Access Control Lists (ACL) provide packet filtering for IP frames (based on address, protocol, or Layer 4 protocol port number or
TCP control code) or any frames (based on MAC address or Ethernet type). To filter packets, first create an access list, add the
required rules and then bind the list to a specific port. This section describes the Access Control List commands.
Command Grup Function
IP ACLs Configures ACLs based on IP addresses, TCP/UDP port
number, andprotocol type
MAC ACLs Configures ACLs based on hardware addresses, packet format,
and Ethernet type
ACL Information Displays ACLs and associated rules; shows ACLs assigned to
each port
501