PLANET SGSD-1022 - Manual (Page 519)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
When using the negotiation command to enable auto-negotiation, the optimal settings will be determined by the
capabilities command. To set the speed/duplex mode under auto-negotiation, the required mode must be specified in the
capabilities list for an interface.
Example
The following Example configures port 5 to 100 Mbps, half-duplex operation.
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#
Related Commands
negotiation
capabilities
negotiation
This command enables autonegotiation for a given interface. Use the no form to disable autonegotiation.
Syntax
[no] negotiation
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When auto-negotiation is enabled the switch will negotiate the best settings for a link based on the capabilities command.
When auto-negotiation is disabled, you must manually specify the link attributes with the speed-duplex and flowcontrol
commands.
If autonegotiation is disabled, auto-MDI/MDI-X pin signal configuration will also be disabled for the RJ-45 ports.
Example
The following Example configures port 11 to use autonegotiation.
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
519