PLANET SGSD-1022 - Manual (Page 420)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
snmp-server engine-id
This command configures an identification string for the SNMPv3 engine. Use the no form to restore the default.
Syntax
snmp-server engine-id {local | remote {ip-address}} engineid-string no snmp-server engine-id {local | remote {ip-address}}
local - Specifies the SNMP engine on this switch.
remote - Specifies an SNMP engine on a remote device.
ip-address -The Internet address of the remote device.
engineid-string -String identifying the engine ID. (Range: 10-64 hexadecimal characters representing 5-32 octets)
Default Setting
A unique engine ID is automatically generated by the switch based on its MAC address.
Command Mode
Global Configuration
Command Usage
An SNMP engine is an independent SNMP agent that resides either on this switch or on a remote device. This engine
protects against message replay, delay, and redirection. The engine ID is also used in combination with user passwords to
generate the security keys for authenticating and encrypting SNMPv3 packets.
A remote engine ID is required when using SNMPv3 informs. (See snmp-server host on page 4-72.) The remote engine
ID is used to compute the security digest for authenticating and encrypting packets sent to a user on the remote host.
SNMP passwords are localized using the engine ID of the authoritative agent. For informs, the authoritative SNMP agent
is the remote agent. You therefore need to configure the remote agent’s SNMP engine ID before you can send proxy
requests or informs to it.
A local engine ID is automatically generated that is unique to the switch. This is referred to as the default engine ID. If the
local engine ID is deleted or changed, all SNMP users will be cleared. You will need to reconfigure all existing users (page
4-81).
Example
Console(config)#snmp-server engine-id local 0123456789
Console(config)#snmp-server engineID remote 9876543210 192.168.1.19
Console(config)#
Related Commands
snmp-server host
show snmp engine-id
This command shows the SNMP engine ID.
420