PLANET SGSD-1022 - Manual (Page 577)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
switchport native vlan
This command configures the PVID (i.e., default VLAN ID) for a port. Use the no form to restore the default.
Syntax
switchport native vlan vlan-id no switchport native vlan vlan-id -Default VLAN ID for a port.
(Range: 1-4094, no leading zeroes)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Setting the native VLAN for a port can only be performed when the port is a member of the VLAN and the VLAN is
untagged. The no switchport native vlan command will set the native VLAN of the port to untagged VLAN 1.
If acceptable frame types is set to all or switchport mode is set to hybrid, the PVID will be inserted into all untagged frames
entering the ingress port.
Example
The following example shows how to set the PVID for port 1 to VLAN 3: .
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
switchport allowed vlan
This command configures VLAN groups on the selected interface. Use the no form to restore the default.
Syntax
switchport allowed vlan {add vlan-list [tagged | untagged] |remove vlan-list} no switchport allowed vlanadd vlan-list -List of
VLAN identifiers to add.
remove vlan-list - List of VLAN identifiers to remove.
vlan-list - Separate nonconsecutive VLAN identifiers with a comma and no spaces; use a hyphen to designate a range of
IDs. Do not enter leading zeros. (Range: 1-4094).
Default Setting
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
577