PLANET SGSD-1022 - Manual (Page 663)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
5.25.5 Multicast VLAN Registration Commands
This section describes commands used to configure Multicast VLAN Registration (MVR). A single network-wide VLAN can be
used to transmit multicast traffic (such as television channels) across a service provider’s network. Any multicast traffic entering
an MVR VLAN is sent to all subscribers. This can significantly reduce to processing overhead required to dynamically monitor
and establish the distribution tree for a normal multicast VLAN. Also note that MVR maintains the user isolation and data
security provided by VLAN segregation by passing only multicast traffic into other VLANs to which the subscribers belong.
Command Function Mode
mvr Globally enables MVR, statically configures MVR group address(es),
orspecifies the MVR VLAN identifier
GC
mvr Configures an interface as an MVR receiver or source port,
enablesimmediate leave capability, or configures an interface as a
staticmember of the MVR VLAN
IC
show mvr Shows information about the global MVR configuration settings,
theinterfaces attached to the MVR VLAN, or the multicast groups assignedto
the MVR VLAN
PE
Table 5-89 Multicast VLAN Registration Commands
mvr (Global Configuration)
This command enables Multicast VLAN Registration (MVR) globally on the switch, statically configures MVR multicast group IP
address(es) using the group keyword, or specifies the MVR VLAN identifier using the vlan keyword. Use the no form of this
command without any keywords to globally disable MVR. Use the no form with the group keyword to remove a specific address
or range of addresses. Or use the no form with the vlan keyword restore the default MVR VLAN.
Syntax
[no] mvr [group ip-address [count] | vlan vlan-id]
ip-address -IP address for an MVR multicast group.
(Range: 224.0.1.0 -239.255.255.255)
count - The number of contiguous MVR group addresses. (Range: 1-255)
vlan-id - MVR VLAN ID (Range: 1-4094)
Default Setting
MVR is disabled.
No MVR group address is defined.
The default number of contiguous addresses is 0.
MVR VLAN ID is 1.
Command Mode
Global Configuration
663