PLANET SGSD-1022 - Manual (Page 396)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
logging facility
This command sets the facility type for remote logging of syslog messages. Use the no form to return the type to the default.
Syntax
[no] logging facility type
type - A number that indicates the facility used by the syslog server to dispatch log messages to an appropriate service.
(Range: 16-23)
Default Setting
23
Command Mode
Global Configuration
Command Usage
The command specifies the facility type tag sent in syslog messages. (See RFC 3164.) This type has no effect on the kind
of messages reported by the switch. However, it may be used by the syslog server to sort messages or to store messages
in the corresponding database.
Example
Console(config)# logging facility 19
Console(config)#
logging trap
This command enables the logging of system messages to a remote server, or limits the syslog messages saved to a remote
server based on severity. Use this command without a specified level to enable remote logging. Use the no form to disable
remote logging.
Syntax
logging trap [level] no logging trap
level - One of the level arguments listed below. Messages sent include the selected level up through level 0. (Refer to the
table on page 4-50.)
Default Setting
Enabled
Level 7 - 0
Command Mode
Global Configuration
Command Usage
Using this command with a specified level enables remote logging and sets the minimum severity level to be saved.
Using this command without a specified level also enables remote logging, but restores the minimum severity level to the
396