PLANET SGSD-1022 - Manual (Page 350)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
VLAN Database
Table 5-1 Command Modes
1. You must be in Privileged Exec mode to access the Global configuration mode.
2. You must be in Global Configuration mode to access any of the other configuration modes.
5.2.10 Exec Commands
When you open a new console session on the switch with the user name and password “guest,” the system enters the Normal
Exec command mode (or guest mode), displaying the “Console>” command prompt. Only a limited number of the commands
are available in this mode. You can access all commands only from the Privileged Exec command mode (or administrator mode).
To access Privilege Exec mode, open a new console session with the user name and password “admin.” The system will now
display the “Console#” command prompt. You can also enter Privileged Exec mode from within Normal Exec mode, by entering
the enable command, followed by the privileged level password “ super ”.
To enter Privileged Exec mode, enter the following user names and passwords:
Username: admin
Password: [admin login password]
CLI session with the SGSD-1022 is opened.
To end the CLI session, enter [Exit].
Console#
Username: guest
Password: [guest login password]
CLI session with the SGSD-1022 is opened.
To end the CLI session, enter [Exit].
Console>enable
Password: [privileged level password]
Console#
350