PLANET SGSD-1022 - Manual (Page 639)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Command Mode
Global Configuration
Command Usage
• First enter this command to designate a class map and enter the Class Map configuration mode. Then use the
match command to specify the criteria for ingress traffic that will be classified under this class map.
• Up to 16 match commands are permitted per class map.
• The class map is used with a policy map to create a service policy for a specific interface that defines packet
classification, service tagging, and bandwidth policing.
Example
This example creates a class map call “rd_class,” and sets it to match packets marked for DSCP service value 3:
Console(config)#class-map rd_class match-any
Console(config-cmap)#match ip dscp 3
Console(config-cmap)#
Related Commands
show class map
match
This command defines the criteria used to classify traffic. Use the no form to delete the matching criteria.
Syntax
[no] match access-list acl-name
acl-name -Name of the access control list. Any type of ACL can be specified, including standard or extended IP ACLs and
MAC ACLs. (Range: 1-16 characters)
Default Setting
None
Command Mode
Class Map Configuration
Command Usage
• First enter the class-map command to designate a class map and enter the Class Map configuration mode. Then use
the match command to specify the fields within ingress packets that must match to qualify for this class map.
• Only one match command can be entered per class map.
Example
This example creates a class map call “rd_class#3,” and sets it to match packets defined in an access list:
639