Logging host – PLANET SGSD-1022 User Manual
Page 395
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
0
emergencies
System unusable
* There are only Level 2, 5 and 6 error messages for the current firmware release.
Default Setting
Flash: errors (level 3 - 0)
RAM: warnings (level 7 -0)
Command Mode
Global Configuration
Command Usage
The message level specified for flash memory must be a higher priority (i.e., numerically lower) than that specified for
RAM.
Example
Console(config)#logging history ram 0
Console(config)#
logging host
This command adds a syslog server host IP address that will receive logging messages. Use the no form to remove a syslog
server host.
Syntax
[no] logging host host_ip_address host_ip_address - The IP address of a syslog server.
Default Setting
None
Command Mode
Global Configuration
Command Usage
Use this command more than once to build up a list of host IP addresses.
The maximum number of host IP addresses allowed is five.
Example
Console(config)#logging host 10.1.0.3
Console(config)#
395