PLANET SGSD-1022 - Manual (Page 609)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Syntax
[no] lldp basic-tlv management-ip-address
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The management address protocol packet includes the IPv4 address of the switch. If no management address is
available, the address should be the MAC address for the CPU or for the port sending this advertisement.
• The management address TLV may also include information about the specific interface associated with this address,
and an object identifier indicating the type of hardware component or protocol entity associated with this address. The
interface number and OID are included to assist SNMP applications to perform network discovery by indicating
enterprise specific or other starting points for the search, such as the Interface or Entity MIB.
• Since there are typically a number of different addresses associated with a Layer 3 device, an individual LLDP PDU
may contain more than one management address TLV.
• Every management address TLV that reports an address that is accessible on a port and protocol VLAN through the
particular port should be accompanied by a port and protocol VLAN TLV that indicates the VLAN identifier (VID)
associated with the management address reported by this TLV.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp basic-tlv management-ip-address
Console(config-if)#
lldp basic-tlv port-description
This command configures an LLDP-enabled port to advertise its port description. Use the no form to disable this feature.
Syntax
[no] lldp basic-tlv port-description
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The port description is taken from the ifDescr object in RFC 2863, which includes information about the manufacturer, the
product name, and the version of the interface hardware/software.
609