PLANET SGSD-1022 - Manual (Page 355)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
The device has two predefined privilege levels:
0: Normal Exec,
15: Privileged Exec.
Enter level 15 to access Privileged Exec mode.
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
“admin” is the default password required to change the command mode from Normal Exec to Privileged Exec.
(To set this password, see the enable password command.)
The “#” character is appended to the end of the prompt to indicate that the system is in privileged access mode.
Example
Console>enable
Password: [privileged level password]
Console#
Related Commands
disable
enable password
disable
This command returns to Normal Exec mode from privileged mode. In normal access mode, you can only display basic
information on the switch's configuration or Ethernet statistics. To gain access to all commands, you must use the privileged
mode. See “ Understanding Command Modes ”.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
The “>” character is appended to the end of the prompt to indicate that the system is in normal access mode.
Example
355