PLANET SGSD-1022 - Manual (Page 423)

User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Field Description
View Name Name of an SNMP view.
Subtree OID A branch in the MIB tree.
View Type Indicates if the view is included or excluded.
Storage Type The storage type for this entry.
Row Status The row status of this entry.
Table 5-23 show snmp view - display description
snmp-server group
This command adds an SNMP group, mapping SNMP users to SNMP views. Use the no form to remove an SNMP group.
Syntax
snmp-server group groupname {v1 | v2c | v3 {auth | noauth | priv}} [read readview] [write writeview] [notify notifyview] no
snmp-server group groupname
groupname -Name of an SNMP group. (Range: 1-32 characters)
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
auth | noauth | priv - This group uses SNMPv3 with authentication, no authentication, or with authentication and privacy.
See “Simple Network Management Protocol” on page 3-39 for further information about these authentication and
encryption options.
readview - Defines the view for read access. (1-64 characters)
writeview - Defines the view for write access. (1-64 characters)
notifyview - Defines the view for notifications. (1-64 characters)
Default Setting
Default groups: public19 (read only), private20 (read/write)
readview - Every object belonging to the Internet OID space (1.3.6.1).
writeview - Nothing is defined.
notifyview -Nothing is defined.
Command Mode
Global Configuration
Command Usage
A group sets the access policy for the assigned users.
When authentication is selected, the MD5 or SHA algorithm is used as specified in the snmp-server user command.
When privacy is selected, the DES 56-bit algorithm is used for data encryption.
For additional information on the notification messages supported by this switch, see “Supported Notification Messages”
on page 3-51. Also, note that the authentication, link-up and link-down messages are legacy traps and must therefore be
enabled in conjunction with the snmp-server enable traps command (page 4-74).
423