Line, Login – PLANET SGSD-1022 User Manual
Page 385
User’s Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
speed*
Sets the terminal baud rate
LC
stopbits*
Sets the number of the stop bits transmitted per byte
LC
disconnect
Terminates a line connection
PE
show line
Displays a terminal line's parameters
NE, PE
Table 5-13 Line Commands
* These commands only apply to the serial port.
line
This command identifies a specific line for configuration, and to process subsequent line configuration commands.
Syntax
line {console | vty}
console -Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
Command Mode
Global Configuration
Command Usage
Telnet is considered a virtual terminal connection and will be shown as “VTY” in screen displays such as show users.
However, the serial communication parameters (e.g., databits) do not affect Telnet or SSH connections.
Example
To enter console line mode, enter the following command:
Console(config)#line console
Console(config-line)#
Related Commands
show line
show users
login
This command enables password checking at login. Use the no form to disable password checking and allow connections
without a password.
Syntax
login [local] no login
385