Metrohm tiamo 2.3 Patch 1 - Manual (Page 1076)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1060 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
[Properties]
Open the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 930).
[Delete]
Delete the calculated measured value selected in the table.
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Open the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 931).
[Properties]
Open the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 931).
[Delete]
Delete the external measured value selected in the table.
5.6.4.16 MEAS TMF
5.6.4.16.1 MEAS TMF - Overview
Dialog window: Method ▶ MEAS TMF ▶ Properties... ▶ MEAS TMF - 'Command
name'
Command for the determination of the transmission factor of a
measurement configuration.
Instruments
This command can be executed with the following device:
Photometer: 089
Appearance
The command has the following appearance: