Metrohm tiamo 2.3 Patch 1 - Manual (Page 58)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
42 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Designation Description Commands
.DBL Total duration for the processing
of the command in s DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS, CAL
Cond, CAL MEAS,
CAL Spec,
STDADD, DOS,
ELT MEAS
.DEF Default value which is defined in
the configuration for an IO port ANALOG OUT,
DIGITAL OUT
.DRI Current and/or last drift for drift
correction in µL/min SET, KFT, KFC,
BRC
.DSC Time for processing all start condi-
tions s DET, MET, SET,
KFT, STAT
.DTI Time for drift correction (time
from the start of the titration to
the end of the command) in s SET, KFT, KFC,
BRC
.EGF Last measured gas flow rate
(measured value following pro-
cessing of the command) in
mL/min MEAS T/Flow
.EME End measured value (measured
value after processing of the com-
mand) in the unit of the measured
value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS,
STDADD, DOS,
ELT MEAS
.ENP Electrode zero point for the sensor
used for the command (dimen-
sionless for pH sensor or in mV for
the ISE sensor) and/or electrode
zero point calculated from the cal-
ibration (for STDADD and CAL
LOOP) DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS T,
MEAS Conc,
STDADD, CAL
LOOP, DOS, ELT
LOOP
.EP{x}.CHA Charge for endpoint x (1…9) in
mA·s KFC, BRC