Metrohm tiamo 2.3 Patch 1 - Manual (Page 158)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
142 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
￭ Reserve devices (modules)
The devices and/or their function units used by the device-dependent
commands in the method are reserved for the duration of the determi-
nation, i.e. they can neither be used in other workplaces nor can they
be operated manually.
￭ Increasing sample number
The sample number is increased by +1.
￭ Increasing statistics counter
If Statistics is switched on, both in the START command and on the
Single determination tab, then the statistics counter will be
increased by +1. If a new method has been loaded or if the statistics
counter corresponds to the setpoint counter, then the current statistics
data is deleted beforehand and the statistics counter is set to 0.
6 - Main procedure
The following actions can be carried out during processing of the method
loaded:
￭ Processing the main track
The status switches to BUSY after the start of the main track. The
main track commands and those of the other tracks it calls up are pro-
cessed in sequence. If tracks which are not free are called up by the
main track, then a waiting period will be observed until these tracks
can be started.
￭ Interrupt and continue run
A determination that is running can be interrupted at any time with
[Hold] and resumed with [Cont]. All active tracks are interrupted and
resumed together when this is done.
￭ Cancel run
A determination that is running can be canceled at any time with
[Stop]. The exit track (if present) is run afterwards and the determina-
tion is stopped.
￭ Stop by error
If an error occurs while a determination is running that causes the
determination to be interrupted, then the error track will be run (if
present) and the determination will be ended.
￭ Processing exit track
If the main track and all of the tracks that it has called up are finished,
then the exit track (if present) will be run and the determination fin-
ished. The status switches to READY after the end of the main track.
7 - Conditioning (only for methods with conditioning)
Conditioning is started with the loaded method in the case of methods
which contain commands with switched-on conditioning. The require-
ment for this is that the Automatic conditioning option is switched on
in the START command. The conditioning starts immediately after the
end of the track which contains the command with conditions.