Metrohm tiamo 2.3 Patch 1 - Manual (Page 978)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
962 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Designation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL Total duration for the processing of the command in s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) = Com-
mand has never ended
.FP{x}.MEA Measured value for the fixed endpoint x (1…9) in the
unit of the measured value
.FP{x}.TEM Temperature for the fixed endpoint x (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint x (1…9) is reached
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value x (1…3) for the last measuring point
on the measuring point list
.LP.EXx External value x (1…3) for the last measuring point on
the measuring point list
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.MA.MEA Maximum measured value (U
ind
) in mV
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MI.MEA Minimum measured value (U
ind
) in mV