Metrohm tiamo 2.3 Patch 1 - Manual (Page 1132)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1116 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Electrodes
This command can be carried out with electrodes of the pH electrode
type.
Appearance
The command has the following appearance:
Parameters
The parameters for the command ELT LOOP are configured in the fol-
lowing dialog window:
￭ ELT LOOP - Properties
Command variables
The following command variables are generated in the method run by the
command ELT LOOP and can be used in formulas under the designation
'Command name.Variable designation':
Desig-
nation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.ENP Electrode slope of the sensor used for the command (in mV
for ISE sensors)