Metrohm tiamo 2.3 Patch 1 - Manual (Page 1210)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1194 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
[Properties]
Opens the dialog window Track call in which the parameters for the
selected track call can be edited(see Chapter 5.6.6.3.3, page 1163) .
[Delete]
Deletes the track call selected in the table.
5.6.6.3.5.6 DOS U - Additional measured values
Tab: Methods ▶ Commands ▶ DOS U ▶ Properties... ▶ Additional measured val-
ues
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings.
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Opens the dialog window Calc. measured value # in which the param-
eters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 930).
[Properties]
Opens the dialog window Calc. measured value # in which the param-
eters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 930).
[Delete]
Deletes the calculated measured value selected in the table.
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)