Metrohm tiamo 2.3 Patch 1 - Manual (Page 1293)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1277
Note
If the sample identifications are still invalid at the start of the method
and are not entered until the time of the REQUEST command during
the run, then the option Check at start in the START command must
be switched off for these method variables.
Sample size
Sample size (initial weight).
Input 1 ... 10 digits.
Default value 1
Device
Unit of sample size.
Selection g | mg | µg | mL | µL | pcs
Default value g
Note
Sample data can be loaded directly from a balance or a barcode
reader. The data import must be enabled for this purpose in the Run
window in which the determination is started (Single determination
or Determination series) and the corresponding devices must be
defined. The dialog window Sample data request will be closed
automatically after the data has been received from these devices.
Note
In the event the option Comments on modification of sample
data (live) is enabled in the Security settings, the dialog window
Modification comment sample data will be displayed after the
sample data is entered, where a Comment and a Reason for the
modification must be entered.