Metrohm tiamo 2.3 Patch 1 - Manual (Page 1379)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1363
Device name
Designation of the device.
Device type
Type of device.
Device serial number
Serial number of the device.
Status
Device status. A device that is ready has the status ok shown in green, a
device that is not ready has the status not ok shown in red.
Note
The device status is permanently monitored and updated for USB devi-
ces only. For Metrohm devices with RS-232 connection, the current sta-
tus at the last access to the device is shown always. For balances, bar-
code readers and generic RS-232 devices, the status cannot be moni-
tored. It will be set to ok after confirmation of the connection test.
Set to work
Date on which the device was added to the device table.
Next GLP test
Date on which the next GLP test is due. If GLP monitoring is switched on
and the set date is before the current date (i.e. the GLP test has not yet
been carried out) then the date will be shown in red.
Remarks
Remarks about the device.
Note
Lines that contain red entries will also show the line number with a red
background.
As soon as a determination is started all the devices or device compo-
nents used in the method (dosing devices, measuring inputs) will be
occupied, i.e. they can neither be used at a different workplace nor
used or configured in manual control until the determination has been
finished. The line for an occupied device is shown in gray letters.