Metrohm tiamo 2.3 Patch 1 User Manual
Page 66
2.4 Formula editor
■■■■■■■■■■■■■■■■■■■■■■
50
■■■■■■■■
tiamo 2.3 Patch 1
Designation
Description
Commands
.MTE
Temperature measurement with
sensor; 1 = on, 0 = off)
DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
Cond, CAL MEAS,
STDADD, DOS,
ELT MEAS
.NMP
Number of measuring points in
measuring point list
DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.OVE
Value of the output at the end of
the command.
Direct controller/2-point-control-
ler: 1 = active, 0 = inactive
PID/PWM: -100 to 100% (value of
the analog output or the pulse
frequency)
CONTROL
.OVS
Value of the output at the start of
the command.
Direct controller/2-point-controller
command status: 1 = active, 0 =
inactive
PID/PWM: -100 to 100% (value of
the analog output or the pulse
frequency)
CONTROL
.PK{x}.ABS
Absorbance of the peak x (1…9)
in mAU
MEAS Spec
.PK{x}.TRN
Transmission of the peak x (1…9)
in %
MEAS Spec
.PK{x}.CNT
Intensity of the peak x (1…9) in
counts
MEAS Spec
.PK{x}.CNR
Intensity of the peak x (1…9) in
the reference spectrum in counts
MEAS Spec