Metrohm tiamo 2.3 Patch 1 - Manual (Page 745)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 729
off
The titration will not be stopped. In older instructions the Delay time
was usually defined as the Stop criterion.
Stop drift
Titration is stopped when the endpoint and the stop drift have been
reached. This parameter is only shown for Stop criterion = drift.
Range 1 ... 999 µL/min
Default value 20 µL/min
Delay time
If the endpoint has been reached, the delay time defined here is awaited
after the last dosing and then the titration is stopped. This parameter is
only shown for Stop criterion = time. The selection inf. stands for infin-
ite.
Titrando, 855
Range
0 ... 999 s
Default value 10 s
Titrino
Range
0 ... 999 s
Default value 10 s
Selection inf.
Stop time
The titration is stopped if the stop time defined here has elapsed since the
start of the titration. This parameter is only shown for Stop criterion =
time and Delay time = inf.
Titrino
Range
0 ... 999999 s
Selection off
Default value off
Endpoint 2
Note
Is activated only for EP1 with ≠ off.
on | off (Default value: off)
Switching endpoint 2 on/off. If this is deactivated all following parameters
are not visible.