Metrohm tiamo 2.3 Patch 1 - Manual (Page 891)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 875
Parameters defining the run of the titration.
Titration direction
Selection of the titration direction. If two endpoints are set, then the titra-
tion direction is already established and the following selection of titra-
tion direction is ignored.
Selection + | - | auto
Default value auto
+
positive measured value alteration
-
negative measured value alteration
auto
The titration direction is determined automatically from the start meas-
ured value and the set endpoint.
Temperature
Manually entered titration temperature. If a temperature sensor is connec-
ted and the Temperature measurement is set on the General/Hard-
ware tab under Sensor to automatic or continuous, then the temper-
ature will be measured continuously. This value is used for temperature
correction in pH measurements.
Titrando, 855
Range
-20.0 ... 150.0 °C
Default value 25.0 °C
Titrino
Range
-170.0 ... 500.0 °C
Default value 25.0 °C
Measuring point recording
Time interval measuring point
Time interval for entering a measuring point in the measuring point list.
Titrando, 855
Range
0.1 ... 999999 s
Default value 2.0 s
Titrino
Range
1 ... 999999 s
Default value 2 s