Metrohm tiamo 2.3 Patch 1 - Manual (Page 766)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
750 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Titrando, 855
Range
0.01 ... 166.00 mL/min
Default value 1.00 (slow), 10.00 (optimal), 166.00
(fast) mL/min
Titrino
Range
0.01 ... 150.00 mL/min
Default value 1.00 (slow), 10.00 (optimal), 150.00
(fast) mL/min
Min. rate
Rate at which dosing is carried out at the very beginning of the titration
and in the control range at the end of the titration. The smaller the
selected minimum rate, the slower the titration.
Range 0.01 ... 9999.00 µL/min
Default value 5.00 (slow), 25.00 (optimal), 50.00
(fast) µL/min
Stop criterion
Stop criterion
The titration us stopped after the last dosing once the endpoint has been
reached and the stop criterion has been fulfilled. The titration can be stop-
ped when a particular drift has been achieved or after a preset time.
Note
The Stop conditions will always stop the titration even if the stop crite-
rion has not been fulfilled or has been turned off.
Selection drift | time | off
Default value drift
drift
The switch-off point will always have the same curve slope dV/dt.
time
The endpoint must be exceeded for a certain time: the Delay time. The
same Delay time with different very small volume increments (depend-
ing on the volume of the exchange or dosing unit) means different
switch-off points.
off
The titration will not be stopped. In older instructions the Delay time
was usually defined as the Stop criterion.