Metrohm tiamo 2.3 Patch 1 - Manual (Page 1600)

8.3 Manual control - Device selection ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1584 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
8.3 Manual control - Device selection
In the subwindow for the device selection, the devices or function units of
devices can be selected, on which the functions are to be triggered man-
ually. Therefore they are displayed in tree-form. Displayed are all devices
configured in the device table with status "ok", device name and (in
brackets) the device type number. The currently selected device is shown
with a blue background. Devices, which are still running manually trig-
gered actions, are shown with red lettering.
8.4 Manual control - Functions
Program part: Manual control
In the subwindow Functions/Parameters, the functions for the manual
control of the selected device and the accompanying parameters can be
selected. In addition, here the measured values for running actions and
messages are displayed.
Depending on the device different functions are possible.
8.4.1 Dosing
8.4.1.1 Dosing - Overview
Program part: Manual control
If in the subwindow for the device selection, the group Dosing device or
a single Dosing device is selected, then the functions and parameters
belonging to these dosing devices are displayed in the subwindow Func-
tions/Parameters.
Dosing functions
The dosing functions for exchange and dosing units are displayed on the
following tabs:
￭ General
￭ Preparing
￭ Filling
￭ Emptying
￭ Fixed volume
￭ Dosing
Instruments
The dosing functions can be carried out with dosing devices that are built
in or connected to the following devices:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 784, 785, 794,
795, 798, 799