Metrohm tiamo 2.3 Patch 1 - Manual (Page 862)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
846 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Designation Description
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.UGE Voltage at the generator electrode for last measuring
point of the measuring point list in V
.MTE Temperature measurement with sensor; 1 = on, 0 =
off
.NMP Number of measuring points in measuring point list
.SME Start measured value (measured value after processing
the start conditions) in mV
.STE Start temperature (temperature after processing of the
start conditions) in °C
5.6.3.7.2 BRC - General/Hardware
Tab: Method ▶ BRC ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device, the electrodes and the stirrer are
defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead.