Metrohm tiamo 2.3 Patch 1 - Manual (Page 1525)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 7 Instruments
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1509
Rack code
Shows the rack code of the rack attached. The rack code corresponds to
the arrangement of magnets on the base of the rack and is read in by the
Sample Processor in order to recognize the rack. If no rack is in position
then the display will be empty.
Number of positions
Shows the number of positions on the rack. If no rack is in position then
the display will be empty.
Shift rate
Sample rack speed of rotation for manual operation.
Range 3 ... 20 °/s
Default value 20 °/s
[Rack Data]
Opens the dialog window Rack data (see Chapter 6.12.3.1, page 1457)
or Rack data (774) (see Chapter 6.12.3.6, page 1462) in which the data
of the rack attached can be displayed and edited.
[Initialize rack]
Initializes the attached rack. This resets the rack, the lift and the robotic
arm, reads out the rack code and transfers the corresponding rack data to
the Sample Processor.
7.9.5 Properties - Dosing device
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Dosing
On the tab Dosing device the number and type of dosing devices con-
nected to the 730 Sample Changer or 774 Oven Sample Processor
is displayed. A maximum of 12 dosing devices of the type 685 Dosimat
or 700 Dosino can be connected.
Dosing devices #
Shows the dosing device type for each dosing device connected.
Note
Connecting the dosing devices is described in the manual for the 730
Sample Changer or 774 Oven Sample Processor. If no dosing device is
connected then the tab will remain empty.