Metrohm tiamo 2.3 Patch 1 - Manual (Page 940)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
924 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Maximum evaluation
on | off (Default value: off)
If this option is activated, then the associated volume for the maximum
measured value will be interpolated from the measuring point list.
Threshold value
The evaluation of the maximum begins as soon as the slope of the curve
exceeds the set threshold value.
Only editable for Maximum evaluation = on, otherwise disabled.
Range 0.1 ... 20.0 °C/mL
Default value 1.0 °C/mL
5.6.3.9.8 TET - Additional measured values
Tab: Method ▶ TET ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings.
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Open the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 930).
[Properties]
Open the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 930).
[Delete]
Delete the calculated measured value selected in the table.