Metrohm tiamo 2.3 Patch 1 - Manual (Page 1127)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1111
Devices
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 857, 904, 905, 906, 907
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command CAL MEAS Conc are configured on
the following 2 tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Command variables
The following command variables are generated in the method run by the
command CAL MEAS Conc and can be used in formulas under the des-
ignation 'Command name.Variable designation':
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has not ever been started
.DBL Total duration for the processing of the command in s
.EME Final measured value (measured value after processing
of the command) in the unit of the measured value
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended