Metrohm tiamo 2.3 Patch 1 - Manual (Page 1369)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.3 Patch 1 ￭￭￭￭￭￭￭￭ 1353
6.4.2.3 Filtering the Audit Trail
6.4.2.3.1 Filter Audit Trail
Program window: Configuration ▶ Tools ▶ Audit Trail... ▶ Audit Trail
The following possibilities exist for filtering entries in the Audit Trail table:
￭ Filter selection in filter bar
￭ Quick filter
￭ Special filter
￭ Last filter
￭ Remove filter
6.4.2.3.2 Audit Trail - Last filter
Menu item: Audit Trail ▶ Filter ▶ Last filter
The most recently applied filter is reactivated with the menu item Fil-
ter
▶ Last filter or with the symbol in the program window Audit
Trail.
6.4.2.3.3 Audit Trail - Quick filter
Menu item: Audit Trail ▶ Filter ▶ Quick filter
A rapid filtration can be carried out in accordance with the content of the
selected table field using the menu item Filter
▶ Quick filter or the sym-
bol in the program window Audit Trail. After this function has been
selected, the field in which the cursor is located will have a colored back-
ground when navigating within the Audit Trail table. At the same time,
the following special filter symbol appears:
By double clicking on it with the left mouse button, the contents of the
field selected in the table will be set as the filter criterion and this filter will
be applied directly to the table.
Note
The quick filter can be used again within the filtered table, so that the
number of entries can be limited step by step.