Metrohm tiamo 2.3 Patch 1 - Manual (Page 272)

4.4 Templates ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
256 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
[Copy]
Copy the template selected in the table and save it under the name Copy
of....
4.4.3.2 Edit curve overlay templates
4.4.3.2.1 Curve overlay - Properties
Dialog window: Database ▶ Tools ▶ Templates ▶ Curve overlay tem-
plates... ▶ Curve overlay templates ▶ [Properties] ▶ Properties - Curve overlay -
'Name'
Template name
Name for the curve overlay template which is saved in the configuration
database per client.
Input 50 characters
Command type
Selection of the command type from which curves are to be overlaid.
Selection DET pH | DET U | DET Ipol | DET Upol | MET pH
| MET U | MET Ipol | MET Upol | SET pH | SET U
| SET Ipol | SET Upol | MEAS pH | MEAS U |
MEAS Ipol | MEAS Upol | MEAS T | MEAS Conc
| MEAS Cond | CAL MEAS pH | CAL MEAS
Conc | CAL Cond | MEAS T/Flow | MEAS TC
Cond | MEAS Ref | MEAS Spec | MEAS Opt |
CAL Spec | KFT Ipol | KFT Upol | KFC | BRC |
STAT pH | STAT U | DOS pH | DOS U | TET
Default value DET pH
Autoscaling
on | off (Default value: on)
If this check box is activated, then the. In this case the fields Start value
and End value cannot be edited.
Tabs
Further properties of a template for the overlaying of curves can be set on
the following 4 tabs:
￭ x axis
Parameters for the graphical display of the overlaid curves on the x
axis.
￭ y axis
Parameters for the graphical display of the overlaid curves on the y
axis.