Metrohm tiamo 2.3 Patch 1 - Manual (Page 1516)

7.8 730 Sample Changer ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1500 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1
Action
The actions can only be edited if monitoring is switched on.
If during monitoring it is found that the validity period has expired then
one of the following actions will be triggered automatically at start test.
Selection Record message | Display message | Cancel
determination
Default value Display message
Record message
The message that the validity period has expired will be automatically
saved with the determination.
Display message
A message is displayed and you can select whether you want to con-
tinue the sequence or cancel it. If the sequence is continued then the
message that the validity period has expired will be automatically saved
with the determination.
Cancel determination
The running determination will be automatically canceled. The follow-
ing message must be confirmed with [OK].
7.8 730 Sample Changer
7.8.1 730 Sample Changer - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
The parameters for the device 730 Sample Changer are set on the fol-
lowing tabs:
￭ General
General device information such as device name, device type, serial
number, etc.
￭ Towers
Properties of Tower 1 and Tower 2 (if present). This tab is only dis-
played if the Sample Changer is connected to the PC via an RS-232
interface.
￭ Rack
Information on the rack attached. This tab is only displayed if the Sam-
ple Changer is connected to the PC via an RS-232 interface.
￭ Dosing device
Properties of the connector and the dosing devices connected to it.
This tab is only displayed if the Sample Changer is connected to the PC
via an RS-232 interface.
￭ RS-232
Selection of the serial interface the device is connected to.