Epiphan Pearl Mini Live Video Production System with 512GB SSD (NA/JP) - Manual (Page 99)

Pearl Mini User Guide Configure network settings
Configure network settings
Pearl devices use DHCP to obtain an IP Address over an Ethernet-based network by default; however, you can
easily change the network settings.
Topics include:
l Network ports used by Pearl Mini
l Verify IP address and MAC address
l Configure a static IP address
l Configure DHCP
l Configure DHCP Option 81
l Configure Dynamic DNS
l Change the HTTP/HTTPS port values
l Perform network diagnostics
To monitor network status information, see View network status
To set up traffic shaping for multicast streams, see Set up traffic shaping .
Network ports used by Pearl Mini
The following table lists the default incoming and outgoing network ports.
Do not block traffic over these ports. If you want Pearl devices to operate properly, make sure that your firewall is
configured to open these ports. Blocking a port will cause the service that uses that port to fail. It is possible to
use the Admin panel to change the default ports that are used for some services.
Table 17 Default incoming network ports for Pearl devices
Port (or range) Protocol Description
22 TCP SSH for remote support. See Support .
80 TCP
HTTP/HTTPS for web-based access to the Admin panel and Epiphan
Live, HTTP/HTTPS API, REST API, HLS streaming (if enabled) and the
live channel preview.
You can change the default HTTP port value using the Admin panel, see
Configure HTTPS .
123 TCP/UDP NTP server, if enabled. See Configure a time server .
319 and 320 UDP PTP server, if enabled. See Configure a time server .
443 TCP
HTTPS for the Admin panel and HLS streaming if enabled. Port is open
only when HTTPS is enabled. You can change the default HTTPS port
value using the Admin panel, see
Configure HTTPS .
88