ChamSys MagicQ User Manual - Manual (Page 104)

MagicQ User Manual 75 / 355
9.16 And Only
The AND ONLY (*) function enables selecting of the common heads between groups. It can be used on pairs of groups or on
ranges of groups. When selecting a number of groups then the * operator can be used to specify that only the heads that are in
both groups are selected.
GROUP 1 * 2 ENTER
This selects heads which are in both groups 1 and 2
And Only can be used with the THRU, + and – operators.
GROUP 1 THRU 4 * 5 THRU 8 ENTER
This select heads which are in one of the groups 1 to 4 and also in one of the groups 5 to 8.
It is possible to use And Only together with the @ operator to set levels directly.
GROUP 1 * 3 @ FULL ENTER
Note that if the option “Select heads and palettes from keypad” is set to “No” – then the * * operator must be used to select
groups from the keypad:
1 * 2 * *
1 THRU 4 * 5 THRU 8 * *
1 * 3 * * @ FULL ENTER