ChamSys MagicQ User Manual - Manual (Page 335)

MagicQ User Manual 306 / 355
42.14.2 Subnet Mask
The sub net mask for the network interface.
For communicating with an Art-Net convertor the the Sub net address must be set to 255.0.0.0.
42.14.3 Send to applications on this PC
This setting is used to send Output data internally to other applications on the same PC. This can be used to connect to a 3rd
party Visualiser or the MagicQ Media Centre on the same PC.
This setting is valid for PCs and Macs only – it is ignored on MagicQ consoles.
42.14.4 Ethernet remote protocol
Enables transmission and reception of ChamSys Remote Protocol for communication over Ethernet (UDP/IP) with external 3 rd
party systems. The options are:
• ChamSys Rem (rx)
• ChamSys Rem (tx & rx)
• ChamSys Rem (tx)
If set to None then any data received is ignored. When transmission is enabled, data can be transmitted from the Macro field of
Cue steps in the Cue Stack.
When using network sessions or multi console operation this option should be set to None.
See ChamSys Remote Ehthernet Protocol and Multiple Consoles for more details.
42.14.5 Playback Sync Port
It is possible to configure the port used for synchronisation of playback between multiple MagicQ consoles. The default port is
6553. If this port interferes with other equipment for any reason then it is possible to change it.
Note that this port is also used for Net Sessions - so it must be the same on all systems using Net Sessions.
42.14.6 Web Server
This is used to enable the in-built Web server which enables remote access to the console functions from other equipment using
web browsers. The option “Enabled CSS” uses improved CSS style sheet web pages.
42.14.7 Web Server Port
The default web server port is 8080.
42.14.8 Gateway address
For future use.
42.14.9 Control net IP address
For future use.