ChamSys MagicQ User Manual - Manual (Page 207)

MagicQ User Manual 178 / 355
Parameter 2 select the channels to respond to. When set to 0, it uses all 14 audio input channels. From 1 to 14 it selects one
channel to respond to. Value 15 selects the left channels, value 16 the right channels.
The mode determines from which grid edge the audio takes effect. The image below shows an audio effect on the internal green,
yellow, red bitmap.
The possible modes are:
0 Graph top Graphic equalizer down FX P2 specifies channels
1 Level top Columns left to right FX P2 specifies channels
2 Level bottom Columns right to left FX P2 specifies channels
3 Level left Rows top to bottom FX P2 specifies channels
4 Level right Rows bottom to top FX P2 specifies channels
5 BMT1 Split into 3 -
Mid,Base,Treble
6 BMT2 Split into 3 -
Base,Mid,Treble
7 BMT3 Split into 3 -
Base,Treble,Mid
8 BMT4 Split into 3 -
Treble,Base,Mid
9 BMT5 Split into 3 -
Treble,Mid,Base
10 BMT6 Split into 3 -
Mid,Treble,Base
64 Graph bottom Graphic equalizer up FX P2 specifies channels
128 Graph bottom/top Graphic equalizer up/down FX P2 specifies channels
192 Graph top/bottom Graphic equalizer down/up FX P2 specifies channels
In Setup, View Settings, Ports, Audio Input select the audio interface. The Audio Max Level defaults to 0 which indicates a full