ChamSys MagicQ User Manual - Manual (Page 333)

MagicQ User Manual 304 / 355
42.13.2 Crossfade controls Playback
This setting enables the user to lock the manual playback section of MagicQ to Playback Fader 1, 2, 9 or 10 regardless of the
currently selected Playback. This is designed for theatrical use where one playback is the master Cue Stack. The default is
“Selected Playback”.
42.13.3 Stomp Playbacks
When the Playback Stomping option is enabled, playbacks that have been fully overridden by other playbacks will be automati-
cally released (stomped).
42.13.4 Intensity (HTP) FX can subtract
This option determines whether one Playback intensity level can subtract from another Playback’s level. When set to “yes” an
FX on one Playback can subtract from the level on another Playback. When set to “no” MagicQ performs pure HTP – i.e. the
highest level (including FX) from all the Playbacks is output.
42.13.5 Go reasserts channels
This setting determines which channels are reasserted when the Go button of a Playback is pressed. The options are “All inc
tracked”, “non tracked” and “All no fade”.
When set to “All inc tracked”, then pressing GO on the Playback will reassert channels that are tracking through the Cue Stack
even if they were being controlled by another Playback. When set to “non tracked” only channels that are recorded as “hard
values” in the current Cue will be reasserted.
“All no fade” forces an immediate change of the channel values controlled by the Playback.
42.13.6 Fader off zero reasserts channels
This setting is used to reassert channels using the fader. This setting is useful when using Cue Stacks with the “Fader Releases”
set to No and “Flash releases” set to No.
When set to Yes, faders reassert the Playback when the level leaves zero. The setting “Go reasserts channels” specifies how the
channels are reasserted.
42.13.7 Next Page changes to next used
This setting enables page changes using the Next Page and Prev Page buttons to only access programmed pages rather than
changing through all pages. Any page can be accessed through the Page Window.
42.13.8 Current Playback follows last touched
This setting makes the Current Playback follow the last Playback fader to be raised. If set to No then the Current Playback is not
changed when faders are raised - it is only changed when SELECT buttons are pressed.
42.13.9 Playbacks S + GO = PAUSE
This setting changes the function of S + GO on Playbacks. By default S + GO steps to the next step without time. This option
enables S + GO to be changed to be a PAUSE function for either Wing Playbacks or all Playbacks. This is useful on Wing
Playbacks or on Mini Wings that do not have physical PAUSE buttons.