ChamSys MagicQ User Manual - Manual (Page 342)

MagicQ User Manual 313 / 355
42.17.11 Playback Sync Slave Mode
When Network Session Mode is set then this specifies whether the Slave synchronises its playbacks to the Master. When set
to “Inhibit PB Sync” the Slave playbacks are not synchronised – this is useful for example when programming a show using
multiple consoles.
For show playback the Slave playbacks are normally synchronised to the Master.
42.17.12 Show data Sync Type
This option is now superseded by the Network Session Mode. For manual configuration of this option see Manual Configuration
of Multi Console .
42.17.13 Show data Sync IP
This option is now superseded by the Network Session Mode. For manual configuration of this option see Manual Configuration
of Multi Console .
42.18 Hardware Settings
42.18.1 Level above 0 to activate LTP
In some circumstances Playbacks may get triggered erroneously even when the fader has not been raised above 0. In these
circumstances setting this level to a level above 0 (e.g. 5) may remove the erroneous triggers.
42.18.2 Hysteresis on fader / encoder moves
In some circumstances faders or encoders may become faulty and generate excess noise – in these circumstances setting this
level to a level above 0 (e.g. 5) may remove the effect of the fault.
42.18.3 Encoder Damping
Use this option on a MagicQ PC Wing to improve the performance of the encoder wheels. This option does not have any effect
on MagicQ consoles.
42.18.4 Touch Screen
The touch screen can be disabled with this setting in case it has gone faulty and is causing problems.
42.18.5 Encoders
The encoders can be disabled in case they have gone faulty and are causing problems.
42.18.6 Faulty Faders Mask
The faders can be disabled in case they have gone faulty and are causing problems. This setting should normally be set to 0.
The following values can be used:
• Set to 1 to disable the main faders.