ChamSys MagicQ User Manual - Manual (Page 292)

MagicQ User Manual 263 / 355
When you have connected your Scene Setter to your the PC and the Digi Utiltly has loaded up, it will automatically look for the
Scene Setter over your network. Once set up you can change the IP Address.
Advanced Scene Setter Configuration
The Scene setter can be remotely configured using a web browser.
Type the IP Address of the device into a web browser. You should see a login box. The username and password are as below.
Login: root Password: dbps
Once you are logged in then you can configure all the settings of the network module in the Scene Setter. Note that if you change
the IP address of the Scene Setter then it will be necessary to use the new address in your browser address bar.
38.5 Setting up the Serial Port
The serial port on the scene setter is set up at ChamSys so it should not be nececsary to change these settings. If the configuration
is lost for any reason then from the web browser connected to the Scene Setter:
• Change Profile
• UDP Sockets
• Enable UDP port using port 6554.
• Then set it to "Automatically Send Data" on to 2.255.255.255 port 6554.
• Send when data is present on the line and match "mahC".
• Untick "Send after following number of idle milliseconds"
Then Apply these settings.
Also set the Basic Serial Port settings to 9600, 8 bits, 1 stop bit, no parity, and no flow control.