IDK MSD-54 Series - Manual (Page 106)

MSD-54 SERIES User’s Guide
106
8.7 Output settings
8.7.1 Output equalizer [OUTPUT EQUALIZER]
HDMI input connector has an equalizer circuit to correct attenuated signals caused when a long cable is
connected, and you can set the amount of equalization based on the cable length.
[Table 8.2] Output equalizer
Cable length Up to 10 meters 10 meters or longer
Setting “OFF” to “MIDDLE” “LOW” to “HIGH”
If you use other manufacturers’ cable, use this table only as a reference.
If a display device that is in a significantly bad condition is connected, the video may be distorted.
[Table 8.3] Amount of corrections
Setting of output
equalizer
Amount of
corrections
OFF 0.0 dB
LOW 1.5 dB
MIDDLE 3.5 dB
HIGH 6.0 dB
1. To set the output equalizer using menu:
MSD-5404 Top
↓ SET key
[FUNCTION SELECT]
OUTPUT SETTING
▲▼keys: Select “OUTPUT SETTING”.
↓ SET key
[OUTPUT SETTING]
OUTPUT EQUALIZER
▲▼keys: Select “OUTPUT EQUALIZER”.
↓ SET key
[OUT1 EQUALIZER]
O FF
▲▼keys: Select the desired output equalizer mode (OFF, LOW,
MIDDLE, or HIGH).
◄►keys: Select the desired output (OUT1 to OUT4).
↓ ESC key: Returns to the previous screen.
2. To set the output equalizer using commands:
@SEQ: Set output equalizer
@GEQ: Get output equalizer
･No correction: OFF [Default]
･Modest correction: LOW
･Middle correction: MIDDLE
･Significant correction: HIGH
For each output