IDK MSD-54 Series - Manual (Page 194)

MSD-54 SERIES User’s Guide
194
■MSD-5401, MSD-5401SL
[Table 8.23] MSD-5401 and MSD-5401SL: Settings of parallel input connectors by factory default
Pin
No.
Description Function
Pin
No.
Description Function
1 No Connection 26 No Connection
2 OUT1-IN1
*2
Selecting input
channel of OUT1
*1
27
AUDIO–OUT1
DOWN/ Phase B Audio output level of
OUT1
*4
3 OUT1-IN2
*2
28
AUDIO-OUT1
MUTE
4 OUT1-IN3
*2
29
DISPLAY1
POWER ON/OFF
Controlling display
device power of
OUT1
*5
5 OUT1-IN4
*2
30 PARALLEL LOCK
Locking parallel
input
*6
6 OUT1-IN5
*2
31 NOT USE
Not assigned
7 OUT1-IN6
*2
32 NOT USE
8 OUT1-IN7
*2
33 NOT USE
9 OUT1-IN8
*2
34 NOT USE
10 OUT1-IN9
*2
35 NOT USE
11 OUT1-OFF 36 NOT USE
12 SWITCHING–V&A
Selecting channel
switching mode
*3
37 NOT USE
13
SWITCHING–
VIDEO
38 NOT USE
14
SWITCHING–
AUDIO
39 NOT USE
15 COMMAND A
Sending control
commands
40 NOT USE
16 COMMAND B 41 NOT USE
17 COMMAND C 42 NOT USE
18 COMMAND D 43 NOT USE
19 COMMAND E 44 NOT USE
20 COMMAND F 45 NOT USE
21 COMMAND G 46 NOT USE
22 COMMAND H 47 NOT USE
23 COMMAND I 48 NOT USE
24
AUDIO-OUT1 UP/
Phase A
Audio output level of
OUT1
*4
49 NOT USE
25 GND 50 GND
*1
Channels (video/audio) to be switched depend on each channel switching mode.
*2
To switch the selected channel and turn “OFF” alternately, set “8.14.6 Toggle“ to “ON”.
If you want to perform the automatic measurement of input timing setting, set “8.14.9 Analog input
measurement“ to “ENABLE” and press one of IN6 to IN9 keys for 2 seconds or longer. For details of
automatic measurement, see “8.6.6 Analog input automatic measurement”.
*3
Channel switching modes of the front panel and parallel input are independent from each other. If you want
to use the fixed channel switching control mode, set it using menu in “8.14.5 Switching mode”.
*4
For audio output level, you can select “PUSH SWITCH” or “ROTARY ENCODER” in “8.14.2 Audio level”.
*5
Toggle operation from the current state. (If it is “OFF”, it is turned to “ON”, and vice versa.)
*6
All parallel inputs are locked. You cannot select a target function that will be locked. This function can also
be set in “8.14.4 Enable/Disable”.