IDK MSD-54 Series - Manual (Page 167)

167
Get error status
1 % 1 E R S T = *
3
*
4
*
5
*
6
*
7
*
8
CR
Get time and status of lamp
1 % 1 L A M P = *
9
(SP) *
10
CR
Get list of input switching
1 % 1 I N S T = *
11
CR
Get projector name
1 % 1 N A M E = *
12
CR
Get manufacturer name
1 % 1 I N F 1 = *
13
CR
Get product name
1 % 1 I N F 2 = *
13
CR
Get other information (optional)
1 % 1 I N F O = *
13
CR
(SP): Space
*
2
Input number, which is any of “1” to “9”, but types and the numbers of selectable input connectors differ
depending on connected projectors.
*
3
Fan error, which is any of 0 to 2.
0: Error not detected or no detect error function
1: Warning
2: Error
*
4
Lamp error. Numbers and meanings are the same as those of the fan error status above.
*
5
Temperature error. Numbers and meanings are the same as those of the fan error status above.
*
6
Cover open error. Numbers and meanings are the same as those of the fan error status above.
*
7
Filter error. Numbers and meanings are the same as those of the fan error status above.
*
8
Other errors. Numbers and meanings are the same as those of the fan error status above.
*
9
Accumulated time of lamp, which is any of 0 to 99999. (For projectors that do not count the accumulated
time, the value is 0 at all times.).
*
10
Whether the lamp illuminates or not (0 or 1).
0: Not illuminate
1: Illuminates
For devices containing several lamps, accumulated time and lightning state for each device are replied
in sequence. For example, if a device containing three lamps, the following command is replied:
“%1LAMP=accumulated time 1(SP) lightning state 1(SP) accumulated time 2(SP) lightning state 2(SP)
accumulated time 3(SP) lightning state 3 CR”
*
11
Source number, which is input switchable. Any of 11 to 59 (Meaning is the same as that of “%INPT”
command). For devices containing several inputs, several statuses separated with a (SP) are sent. For
example, for a device having two inputs, “%1INST= source number1(SP)source number2CR” is sent.
*
12
20 to FF in hex; up to 64 characters.
*
13
20 to 7F in hex; up to 32 characters.
To check reply commands of PJLink commands, register reply commands of [Table 8.17] to [Table 8.18] by
following ”8.12.2 Reply commands“ (“xxxx” specifies the command itself of [Table 8.15].)