IDK MSD-54 Series - Manual (Page 48)

MSD-54 SERIES User’s Guide
48
[If edges are cut off due to enlargement in the display device side]
If video is input to a wide TV or the like, the video is automatically enlarged and displayed, and sometimes
edges are cut off. In this case, change the display size (such as “Full display”, “Wide display”). If the problem
is still not resolved, set “8.3.10 Output position” and “8.3.11 Output size”.
To set output position and size:
■ Steps
1
Select “OUTPUT FRAME” in “8.3.15 Test pattern”.
2
Set the display position by following “8.3.10 Output position” to match the upper left of the display
device and test pattern.
3
Reduce the test pattern by following “8.3.11 Output size” to match the lower right of the display device
and the test pattern.
4
Set the test pattern to “OFF”.
Edges of the top, bottom,
right, and left are cut off
due to enlarged display in
the display device side. Test pattern
Match the upper left of the
test pattern with the upper
left of the display device.
Match the upper right of the
test pattern with the upper
right of the display device.
[Figure 8.13] Setting position, size, and masking of output side