IDK MSD-54 Series - Manual (Page 88)

MSD-54 SERIES User’s Guide
88
8.5.4 Signal type of analog input
[ANALOG INPUT TYPE]
You can set the signal type that is input from an analog input connector:
･AUTO [Default] ･VIDEO AUTO
･RGB ･VIDEO (for composite video)
･YPbPr ･Y/C (for S-video)
If you select “AUTO”, the type of input signals is detected automatically. In cases where the detection fails and
video is not output correctly, set the input type manually. With “AUTO”, the automatic detection of S-Video
may fail. If both composite video and S-Video are input at the same time, select “VIDEO AUTO”; if only
S-Video is input, select “Y/C”.
Note:
For video of a monochrome camera or VHS tape with a bad recording condition or the like, automatic
detection may fail. In these cases, select “VIDEO AUTO”, “VIDEO” or “Y/C”.
1. To set the signal type of analog input using menu:
MSD-5404 Top
↓ SET key
[FUNCTION SELECT]
INPUT SETTING
▲▼keys: Select “INPUT SETTING”.
↓ SET key
[INPUT SETTING]
ANALOG INPUT TYPE
▲▼keys: Select “ANALOG INPUT TYPE”.
↓ SET key
[IN6 ANALOG TYPE]
A UTO
▲▼keys: Select the desired signal type.
( AUTO, RGB, YPbPr, VIDEO AUTO, VIDEO, Y/C )
◄►keys: Select the desired input (IN6 to IN9).
↓ ESC key: Returns to the previous screen.
2. To set the signal type of analog input using commands:
@SAI: Set analog input type
@GAI: Get analog input type
For each input port/input signal