IDK MSD-54 Series - Manual (Page 47)

47
8.3 Setting Position, Size, and Masking
Position, size, and masking can be set for each input and output. Normally, set them for each input. If edges
are cut off due to enlarged display in the display device side or if enlarging output video for all inputs at once,
set them for the output side.
Video is enlarged according to the setting of
input side and top/bottom/right/left sides are
cut off slightly.
Default values of output side is not changed.
Position and size are not changed.
[Normally, set the position, size, and masking for each input in the input side.]
Default values of input side is not changed.
Position and size are not changed. Video size is reduced in the output
side and black bars are displayed at
top/bottom/right/left. Settings set in the output side are applied
to output video.
Video is enlarged according to the setting of
input side and top/bottom/right/left sides are
cut off slightly. Video is enlarged according to the setting of
output side and top/bottom/right/left sides are cut
off slightly.
Video enlarged in the input side is enlarged
again in the output side.
[You can enlarge video for each input and output side separately.]
[Set the position, size, and masking in the output side if edges are cut off due to enlarged display in
the display device side.]
Settings set in the input side are applied to
output video.
[Figure 8.12] Setting position, size, and masking of I/O