IDK MSD-54 Series - Manual (Page 94)

MSD-54 SERIES User’s Guide
94
8.6.4 Vertical start position [V START]
･Vertical start position: 10 to 2048 (Equal or less than [Total vertical lines-vertical display period])
[Default]: Depends on input signals
Vertical
synchronizing signal
Video signals
Vertical start position = Lines between the start of vertical synchronous signal and start of video signals
Vertical display period
Total vertical lines
[Figure 8.34] Vertical start position
The settable range depends on the total number of lines of input signals (the MSD counts automatically) and
“8.6.5 Vertical display period”. If the set value is [Total number of vertical lines > Vertical displayed period >
Vertical start position] and the set value of vertical start position exceeds the limit value by changing the
vertical display period, the vertical start position is set to the limit value automatically.
1. To set the vertical start position using menu:
Top
↓ SET key
▲▼keys: Select “INPUT TIMING”.
↓ SET key
▲▼keys: Select “V START”.
↓ SET key
▲▼keys: Set the vertical start position.
◄►keys: Select the desired input (IN1 to IN9).
↓ ESC key: Returns to the previous screen.
Note:
You can set the vertical start position only if there is an input signal. If no signal is
input, you cannot set the position, and the message shown right is displayed.
2. To set the vertical start position using commands:
@SVS: Set vertical start position
@GVS: Get vertical start position
MSD-5404
[FUNCTION SELECT]
INPUT TIMING
[INPUT TIMING]
V START
[IN6 V START]
3
5 LINE
[IN6 V START]
NOT AVAILABLE NOW
For each input port/input signal