IDK MSD-54 Series - Manual (Page 239)

239
8.17.4 Tally outputs [COMMAND Tally]
You can set the state of Tally output connector for when MSD is turned on.
This setting is valid only to the Tally output connector set to “PRESET COMMAND” in “8.15.1 Assigning
functions”.
･AUTO
･OFF [Default]
･ON
If you select “AUTO” and turn on the MSD, the previous state of Tally output connector will be applied. To fix
the state, select “OFF” or “ON”.
[Table 8.37] Tally output state
Setting Previous Tally output
Tally output that will be applied
when turning ON
AUTO
OFF OFF
ON ON
*
OFF (Default) OFF
ON ON
*
* Even if you set it to “AUTO” or “ON”,”OFF” is output for approximately two seconds after turning off the MSD,
and then “ON” will then be output.
1. To set Tally output using menu:
MSD-5404 Top
↓ SET key
[FUNCTION SELECT]
POWER ON SETTING
▲▼keys: Select “POWER ON SETTING”.
↓ SET key
[POWER ON SETTING]
COMMAND TALLY
▲▼keys: Select “COMMAND Tally”.
↓ SET key
[COMMAND TALLY]
O FF
▲▼keys: Select the desired Tally output mode. (AUTO, OFF, ON)
↓ ESC key: Returns to the previous screen.
2. To set Tally output using commands:
None